ã= Safety instructions Warning Knives and other utensils with sharp points Delivery must be placed in the cutlery basket with the points downwards or horizontally on – Check the packaging and dishwasher immediately for damage caused in the knife shelf *. transit.
Damage Getting to know your – The appliance may be repaired and appliance opened up by a technician only. To do this, disconnect the appliance from the Diagrams of the control panel and the power supply. Pull out the mains plug interior of the appliance can be found in or switch off the fuse.
– Find out about the hardness value of Water softening system your tap water. Your water utility company will help you with this. To ensure good washing results, the – Setting can be found in the water dishwasher requires soft water, i.e. hardness table.
Switching off salt refill indicator/ Special salt water softening system If the salt refill indicator X is impaired Using special salt (e.g. when using combined detergents Always refill with special salt immediately containing salt component), it can be before switching on the appliance. This switched off.
Setting amount of rinse aid Rinse aid The amount of rinse aid dispensed can be set in 4 stages. Accordingly 0, 1, 2 or 3 As soon as the rinse-aid refill indicator P displays are lit (see water hardness table). is lit on the fascia, there is still a rinse-aid Factory setting: 2.
Loading the dishwasher Utensils – Remove large food remnants. It is not necessary to prerinse utensils under Not suitable running water. – Cutlery and utensils made of wood. – Place the utensils so that – Delicate decorative glasses, craft and –...
Cutlery basket Detergent You should always place cutlery unsorted with the points downwards. You can use tablets as well as powder To prevent injuries, place long, pointed or liquid detergents for dishwashers, but implements and knives on the knife shelf. never use washing up liquid.
Adding detergent Combination detergent – If the detergent dispenser 1R is still Apart from conventional detergents (Solo), closed, press the lock 1Z to open the a number of products are offered with detergent dispenser. additional functions. These products contain not only the detergent but also Pour detergent into the dry detergent rinse-aid and salt replacement substances dispenser 1R only (insert tablet flat,...
Overview of programmes The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia. Type of utensils Type of soiling Programme Possible additional Programme sequence options Prerinse very adhesive burned- Clean 70°...
Additional options Washing the dishes Programme data * depending on model Additional options can be set with the The programme data (consumption buttons H. values) can be found in the summary of instructions. This data refers to normal Ÿ Express Wash * conditions and the water hardness set value 2.
Timer programming * Terminating the programme (Reset) * depending on model – Press START button 8 for approx. You can delay the start of the programme by 3, 6 or 9 hours. 3 sec. – Switch on ON/OFF switch (. The End display h is lit.
Filters Maintenance and care The filters 1* keep large foreign objects in the rinsing water away from the pump. A regular inspection and maintenance of These foreign objects may occasionally your machine will help to prevent faults. block the filters. This saves time and prevents problems.
Spray arm Waste water pump Limescale and dirt from the rinsing water Large food remnants in the rinsing water may block nozzles and the bearing not retained by the filters may block the assemblies of the spray arm 1". waste water pump. The rinsing water is then not pumped out and covers the filter.
Detergent residue in the detergent Troubleshooting dispenser. – Dispenser was damp when filled. The majority of faults which could occur in “Check water supply” display ` lights daily operation can be rectified by the user. This ensures that the appliance is –...
Refill indicator for salt X and/or rinse- White stains on the utensils/glasses aid P is not lit. remain milky. – Refill indicator/s switched off. If phosphate-free detergents are used with hard tap water, white deposits may be – Adequate salt/rinse-aid available. deposited more easily on utensils and Refill indicator for special salt X is lit.
Customer service Installation If the advice given does not resolve your The dishwasher must be connected problem, please contact your customer correctly, otherwise it will not function service. Contact details can be found on properly. The specifications for the inlet the back cover of this instruction manual and outlet as well as the electrical or in the enclosed customer service list.
– Some models: – Connect the waste-water hose to the drainage connection of the siphon with The plastic housing on the water the enclosed parts. connection contains an electric valve, the connecting cables are in the supply Ensure that the drainage hose is not hose.
Removing the appliance Waste disposal Also observe the sequence of worksteps here. Both the packaging of new appliances and – Disconnect the appliance from the the old appliances themselves contain power supply. valuable raw materials and recyclable materials. – Turn off the water supply. Please dispose of the individual parts –...
Page 22
Childproof lock (door lock) * To open the door, move lever to right and pull door handle. Always close the appliance door completely when you leave the appliance. This is the only way you can protect your children from potential dangers.
Page 23
The tap should only be turned off if you are absent from home for a prolonged period, e.g. several weeks holiday. Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München To book an engineer visit and product advice...