ADC HiGain HLU-200 User Manual page 20

Alarms
Table 4. HLU-200 List 1E Diagnostic Messages (Cont.)
Message Full Name
PWR FEED OFF Power Feed Off
PWR FEED Power Feed Ground
GND
BER Bit Error Rate
BAD RT? No response from
HRU
VER HLU Software
Version #
LIST 0xL HLU's List #
FRM Frame: SF, ESF,
UNFR, NONE
CODE Line Code: AMI, B8ZS This is the line code that the HLU is set to
14
Description
HDSL span power has been turned off by
setting the PWFD option to DIS or HDSL span
power has been turned off by use of the
A1LB/A2LB/A5LB Intelligent Office Repeater
(IOR) Power Down code.
One of the HDSL loops has been grounded.
A system BER alarm is in effect.
The HLU does not receive any
response from the HRU. Thus, the HRU
integrity is questionable.
This displayed during the System
Settings review mode. Depress the MODE
button for 3 seconds to enter System Settings
review mode.
Displayed during System Settings
review mode defined above.
Defines the type of frame pattern
being received from the DSX-1.
Displayed during System Settings.
receive and transmit at its T1
interfaces. Displayed during System Settings
mode defined above.
September 25, 1998
350-200-115-02, Issue 2
HLU-200 List 1E