Philips WP3810 User Manual page 10

English
10
1 Remove the attachment nut and the adapter from the water
purifier (Fig. 8).
2 Remove the aerator cap from the tap and pass the attachment nut
over the spout. Take out the original adapter and screw the
matching adapter (B-type) onto the tap (Fig. 9).
3 Tighten the adapter further with a coin (Fig. 10).
4 Firmly screw the attachment nut onto the water purifier
housing (Fig. 11).
installation C-type adapter
- For taps with an aerator (threaded inside) (Fig. 12).
1 Remove the attachment nut and the adapter from the water
purifier housing (Fig. 13).
2 Remove the aerator cap from the tap. Take out the original adapter
and screw the matching adapter (C-type) onto the tap through the
attachment nut. (Fig. 14)
3 Tighten the adapter further with a coin (Fig. 15).
4 Firmly screw the attachment nut onto the water purifier
housing (Fig. 16).
installation d-type adapter
- For taps other than A, B or C. (Fig. 17)
1 Remove the attachment nut and the adapter from the water
purifier housing (Fig. 18).
2 Take out the original adapter and screw the D-type adapter onto
the water purifier housing. (Fig. 19)
3 Push the water purifier housing onto the tap from below and
tighten the 4 screws evenly (Fig. 20).
4 Screw the attachment nut firmly onto the water purifier
housing (Fig. 21).
Make sure the rubber washer is firmly pushed against the tap to prevent
water leakage.