Wireless Connection With Static Ip Address - Philips Streamium NP2900 User Manual

1
Select your network from the list of
found networks and confirm.
• Enter the encryption key (if required)
and confirm.
• NP2900 acquires the automatic IP
address.
• NP2900 shows the confirmation for
the connection to the network.
• NP2900 shows the prompt for the
connection to the Internet.
2
Select [Yes] to connect to the Internet.
NP2900 shows the confirmation for
»
the connection to the Internet.
Note
•
You can enter more than one encryption key.
In this case, NP2900 prompts you to select the
default encryption key.
Wireless connection with static IP
address
This is how to navigate and select with the
remote control:
• Press or to select a menu option.
OK to confirm a selection.
• Press
BACK
• Press to go back to the
previous screen.
• Press HOME to go to the Home menu.
The alphanumeric buttons of the remote
control are multi-function buttons:
• To select a number or an alphanumeric
character, press a button once or
repeatedly until you see the number or
alphabetic character in the display of
NP2900.
• To cycle through the alphanumeric
characters that are available, press a
button repeatedly.
• To delete the last character entry from
the display, press CLEAR.
• To delete the whole last line entry
from the display, press and hold
CLEAR.
The onscreen display guides you
through the process of connecting
NP2900 to your home network and
the Internet. This section describes
the typical wireless setup with static
IP address. You can also follow the
onscreen prompts for advanced
configurations that are not described
in this manual.
1
Ensure that your network name and
network password or encryption key are
available.
2
Turn on your wireless access point or
wireless router with broadband Internet
access.
3
Turn on NP2900.
4
Press SETTINGS, to go to the Settings
menu.
5
Select [Wireless (WiFi)] to start the
network setup process.
• For wireless routers with Wi-Fi
protection system (WPS) that supports
push button configuration (PBC): On the
router, press the WPS PBC push button
to activate. On NP2900 press OK to
confirm.)
• For wireless routers with Wi-Fi
protection system (WPS) that supports a
personal identification number (PIN): On
NP2900 select WPS PIN, then enter the
displayed PIN on the router.
• For other wireless routers:
» NP2900 searches for networks.
1
Select your network from the list of
found networks and confirm.
• Enter the encryption key (if required)
and confirm.
• NP2900 tries to acquire an
automatic IP address.
2
Press BACK
to enter your IP address
manually.
3
Enter your static IP address and confirm.
» NP2900 shows the confirmation for
the connection to the network.
EN
29