Flyer AC802 Instruction Sheet

Rear Storage Basket - Small Instruction Sheet
Model #AC802
Compatibility: Flyer M880, Flyer
TM

WARNING!

• Read all safety warnings and instructions before using the
product. Failure to follow warnings and instructions may result
in serious injury or death.
• You must also reference the owner's manual that was shipped
with your Flyer™ eBike before using this accessory:
• Incorrect assembly, maintenance, or use of your Flyer™
accessory can cause component failure, loss of control,
serious injury, or death. Please note, the assembly of Flyer™
accessories require special tools and mechanical skills. It is
highly recommended that the assembly and adjustment are
completed by a reputable bicycle mechanic when possible.
• Only for use with the Flyer™ eBike.
• Adding load to accessories may lessen the stability or alter the
riding characteristics of the bicycle.
• Maximum Load Capacity: 50 lbs
• Step off of the bike and put the bike on its kickstand before
assembling, adjusting or interacting with accessories.

Installing Rear Storage Basket Frame

A
B
L885
TM
A. For L885 models, remove the wooden seat that is covering the threaded inserts.
B. Lay the basket on the bike's rear rack and make sure the holes in the basket line up with the
threaded inserts.
C. Slide a lock washer onto each 27mm screw. Next, slide a washer onto each screw.Locate the two circle
shaped holes in the basket, and finger tighten two screws through the holes into the threaded inserts.
D. Finger tighten the other two screws into the slot shaped holes.
E. Tighten all screws with the Allen Key to 3Nm.
C
continued on back

HARDWARE

4X - M5 27mm
A B
Pan Head Screw

TOOLS

M4 Allen Key
M3 Allen Key
D
C
4X - M5 Lock 4X – Washer
Washer
E
1