Advertisement
Door Handles
The door handles may be packed inside the freezer.
To fit a door handle
Bracket
Front of
door
Handle
Bracket
Shelves
The wire shelves sit on shelf clips. The shelf clips twist onto the shelf support strips in the cabinet interior. The shelves
may be positioned at different heights to suit various product. Use the numbers on the shelf support strips to assist with
setting the shelf clips at the same height.
To f it a shelf clip:
Twist anticlockwise onto
the shelf support strip.
Loading product
Let the freezer run for 30 minutes before loading it with product for the first time. When loading the shelves with
:
product
Top
Front
LOAD LIMIT
Back
Internal Airflow
Load Limit
Leave 25 mm space
Do not load product
between product and
above the load limit
the back of cabinet
indicators on the
interior
cabinet interior sides.
Freezer
1.
A metal spring is fitted inside the
handle mounts. Ensure the springs
point up.
Spring clip
(pointing up)
3.
Place BOTH handle mounts
simultaneously onto both door
brackets. Then push the handle
down onto the brackets until the
handle locks in place.
4. If the handle doesn't lock into place,
check that the spring clips are
pointing up and try again. If only one
end of the handle locks into place,
remove the door handle and refit
with both handle mounts located
onto the brackets.
MAX
46kg
per shelf
Shelf Loading
Do not overload the
shelves.
To remove a door handle
Handle
Handle mount
Bracket
Catch
Bracket
Catch
To remove a shelf clip:
Pull the centre tab up and
twist off clockwise.
Shelf Flexing
Remove product if the
shelf is flexing.
Refrigeration
Refrigeration
1.
Peel back the door gasket from
behind the handle mounts on the
inside of the door frame.
2. Unscrew the handle mounts through
the holes on the inside of the door
frame, and remove the handle.
3.
Only unscrew the top and bottom
screws. Do NOT unscrew the middle
screw.
4. Remove the bracket/s from the
handle mount by pressing the
bracket in and down until it unclips
from the handle mount.
5.
Fit and screw the bracket/s back
onto the door. Ensure the catches
are pointing up as pictured.
6. Clip the gasket back into place on
the inside of the door frame. If the
gasket is out of shape, use a hair
drier to heat and reshape it.
To adjust the shelf clip
height:
Pull the centre tab up and
slide up or down as
required. Once in position,
ensure it clicks into place.
Cabinet Floor
Shelf Overhang
Do not let product
Do not load product
on the cabinet floor.
overhang the shelves.
Use the shelves.
Advertisement
