Flipped Mounting Example - WCP -EX-0008 Application Manual

WCP-EX-0008 - Application Guide
(Rev 1)

Flipped Mounting Example

For this mounting example, you will need 2 Aluminum Nutstrips cut to 3". For one of the
nuststrips, drill out the two holes marked in green to #9.
Remove the two #10-32 x 3-1/2"L bolts indicated in the image below. Drill out the
corresponding tapped holes on the Gearbox Plate clearance for #10-32 bolts. Install the
nutstrips as shown in the image below using the indicated bolts.
Table of Contents Page 6
wcproducts.com