Electrolux EVEP916 Installation Manual

Installation guide
90cm freestanding cookers
Your freestanding cooker is designed to fit into a 900mm wide gap
between standard kitchen cabinets. The appliance integrates with the
kitchen cabinets by matching the height, depth and kick panel. The
cooker may also be installed at the end of a line of benches or with a
free space either side. In addition, a slot-in type installation is catered for
allowing a continuous cabinetry kick panel to be used.
WARNING
• The cooker must be installed and serviced only by an authorised
person.
• A Certificate of Compliance MUST be supplied to be kept by the
customer.
• The packing materials must be removed before you install the cooker.
• The surrounding kitchen cabinets must be able to withstand 85°C.
Electrolux WILL NOT accept responsibility for damage caused by
installation into kitchen cabinets which cannot withstand 85°C.
• The pipes used for installation MUST have sufficient loops so the
cooker can be moved for service (gas models).
• The vents, openings and air spaces MUST NOT be blocked.
• Two anti-tilt brackets are supplied and stored in the base of the
packaging
• The anti-tilt brackets MUST be installed to avoid accidental
tipping (freestanding and slot-in models).
• You MUST NOT lift or pull the cooker by the door handle.
• The cooker MUST be checked every five years.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
• The appliance must not be installed behind a decorative door in
order to avoid overheating.
• Due to the weight (95-100kg) and size of the cooker, 2 persons are
required to install it.
Gas model clearance requirements
• Ensure the appliance is installed in accordance with AS/NZS 5601.1
or AS/NZS 5202.2 while paying close attention to the clause on
"Cooking Appliances" with regards to clearances to combustible
surfaces and material, clearances to rangehoods and exhaust
fans. This is to ensure clearances of 200mm from burners to vertical
combustible surfaces. Observe the minimum dimension of 100mm
from each side of the cooker to combustible surfaces.
• When setting the cooker height, ensure the top of the cooker is at
least 10mm higher than the level of the benchtop.
To access your detailed user manual simply scan the QR code on your
smart phone.
For more detailed information and installation guide refer to user manual
at electrolux.com.au/support/manuals
© 2021 Electrolux Home Products Pty Ltd. E_INS_FS_90_Cooker_A4_Sep21 A21742501 Rev A ECN 147478
Dimensions
Splashback
The splashback is secured to the back of the cooker.
REMOVE the splashback before installing the feet.
EFEP916, EFEP956
1