Page 2
This document is protected by copyright. Do not copy or publish this document or parts of it without written permission of Avantes BV. Product specifications and descriptions in this manual are subject to change without notice. Avantes BV will not be responsible for errors and omissions in this manual or for direct or incidental damages in connection with the use of this device or information.
Page 3
Table of Content Introduction ...................... 3 AvaLight-HPLED ....................4 Quick start ....................4 I/O connector ....................5 Settings for PWM Mode ................... 5 Specifications ....................6 Technical data ..................... 6 Ordering information ..................6 Technical support....................7 Getting Help ....................7 AvaSoft and light soures ..................
Page 4
To make sure you get the best out of its performance, it is perfectly compatible with all Avantes AvaSpec spectrometers. The AvaLight-HPLED works from the UV light to the VIS light, it depends on the choice of the wavelength for the HPLED. There are seven different wavelengths available for the HPLED:...
Page 6
2.2 I/O connector For PWM mode to be controlled by software it is needed to connect an AvaSpec spectrometer to the AvaLight-HPLED with the interface cable IC-DB26-2. Now it is possible to control the output operation mode by software (AvaSoft).
Page 8
4 Technical support 4.1 Getting Help If you have any questions, comments or requests concerning your AvaLight-HPLED or the AvaSoft software, please go to: http://www.avantes.com In case you have any questions or need support, please send us an email via support@avantes.com...
Need help?
Do you have a question about the AvaLight-HPLED and is the answer not in the manual?
Questions and answers