Table of Contents
Advertisement
CPD-220AS
2-5. D BOARD REMOVAL
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
removing the anode.
• REMOVING PROCEDURES
a
1
Turn up one side of the rubber cap in
the direction indicated by the arrow a.
• HOW TO HANDLE AN ANODE-CAP
1
Don't hurt the surface of anode-caps with shartp shaped material!
2
Don't press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3
Don't turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.
All manuals and user guides at all-guides.com
Anode cap
1
CN507
CN607
CN501
2
Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow b.
2
CN311
GND
CN503
GND
Two screws
8
D board
9
(+BVTP 3 x 12)
b
– 12 –
A block
Screw
3
(+BVTT 4 x 8)
Cable stopper
4
Two screws
7
(+BVTP 3 x 12)
Two screws
5
(+BVTP 3 x 12)
Cable blacket
6
GND
CN601
Anode Button
3
When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow c.
c
Advertisement
Table of Contents
