Firstech FTI-HDP6 Vehicle Coverage & Preparation Notes

FTI-HDP6: Vehicle Coverage and Preparation Notes
Make Model
DL-HA6
Honda Accord PTS MT
Firmware:
This installation requires BLADE-AL(DL)-HA6 firmware, flash module and update the controller firmware before installing.
Lights:
Type B parking light control interfaces with separate auto-light and park-light circuits at the headlight switch connector,
the included adapter provides these connections without having to cut any vehicle wiring, please ensure proper configuration.
The headlight switch cable included in the latest versions of the kit provides connections for parking light and auto-light control.
Use only the BLACK Type B connector. Caution: Using the WHITE Type A connector will damage the light switch.
When using the included adapter, the parking lights ( - ) and GWR connections in the CM I/O connector must be removed
and replaced with wires from the included headlight switch adapter, as illustrated.
PCU Connections:
The 28-pin connector at the Smart PCU can be either LIGHT BROWN or GRAY, and Smart PCU locations vary by model,
please consult the component locator on the following page for the proper location.
Manual Transmission Clutch Bypass: Vehicles equipped with a manual transmission require additional wiring in order to provide
the required clutch signal. The red/black negative starter output of the CM7/X series controller must be connected to the vehicle
clutch status wire (brown, in the 2-pin connector at the clutch switch (top of clutch pedal assembly).
FTI-HDP6: Installation and Configuration Notes
A REQUIRED CONNECTIONS
B REQUIRED CONFIGURATION
C CONNECTOR COLORS VARY
REQUIRED CONNECTION
D
REQUIRED CONNECTION
E
Year Install
2013-17 Type 1
(CONNECTOR MODIFICATION REQUIRED)
FEATURE COVERAGE
CAN Lights PCU
Park / Auto
PCU Type B LSC
Clutch I/O Changes
Green White/Blue
Brown N/A
CM7000/7200 Cut loop for A/T
CM-900S/900AS
CM900AS/900S Jumper