Disc Cleaning, Power Failure - NexxTech 1219769 Owner's Manual

DISC CLEANING, POWER FAILURE

Cleaning the Disc
1. To clean a disc use the following methods.
NOTE: Do not touch the rainbow colored side.
2. To wipe a disc, use only a soft cloth. Do not
use benzene or thinner which will damage
the disc. The disc should always be wiped in
a straight line from the center to the edge. It
should never be wiped in a circular motion.
3. Never place the disc on other equipment or
near any heat source. Avoid areas where the
disc may be subjected to direct sunlight for
long periods.
Power Failure
When AC power is interrupted, both time and
alarm settings are lost (unless back-up batteries
are installed). Once power is restored the
digital display will blink to show that power was
interrupted and you will have to reset time and
alarms.
Battery Back-up
To keep alarm and time settings in the memory
during a brief power failure or accidental removal
of the AC power cord from power supply, install
2 "AAA" batteries (not included) into the battery
compartment on the underside of the unit.
BATTERY BACK-UP
(Battery not included)
In the event of a power failure, this unit will
automatically switch to a battery stand-by circuit
when batteries are installed. Open the BATTERY
COMPARTMENT on the bottom of the unit and
install 2 x AAA batteries. It is recommended to use
alkaline batteries for back-up and to change the
batteries every year, or after a power outage of
more than 12 hours.
Maintenance and Care
1. Electronic products should never be subjected
to extreme temperatures or high humidity to
ensure good performance and a long lifetime.
The clock radio should not be placed in bathing
areas, or around stoves and radiators, etc.
Always leave sufficient space around the unit
for ventillation.
2. If necessary, only clean the cabinet of the
unit with a soft, dampened piece of cloth, (be
sure the AC power cord is unplugged from the
outlet). Never use a polish or a strong detergent
for cleaning since this can damage the finish of
the cabinet.
3. If the electric cable is damaged, it must be
replaced by the manufacturer, or by qualified
personnel, in order to avoid danger.
3