Power Sources; Player Maintenance - NexxTech 1219769 Owner's Manual

WARNINGS
The FCC Wants You To Know
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed or used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
1) reorient or relocate the receiving antenna;
2) increase the separation between the equipment and the receiver;
3) connect the equipment to an outlet on a circuit different from that to which the receiver is connected;
4) consult the dealer or an experienced radio/TV technician for additional suggestions.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment. Where shielded interface cables have been provided with the product or specified additional components or accessories
elsewhere defined to be used with the installation of the product, they must be used in order to ensure compliance with FCC regulation.
Canadian DOC statement
DOC Class B Compliance - This Class B digital apparatus complies with Canadian ICES-003.

POWER SOURCES

Power Connection
1. Plug the AC 120V Power Cord into an AC household outlet.
2. For battery back-up in case of power failures, insert two alkaline "AAA" batteries (not included), into the
battery compartment on the underside of the unit.
3. The batteries will remember the time during a power outage, but will not display it.
4. Normal display and function will resume when power is restored. Replace the batteries annually.
NOTE: No battery is needed for normal operation.

PLAYER MAINTENANCE

Cleaning the Cabinet
IMPORTANT: Disconnect from power supply before cleaning. Wipe with a soft cloth. If the cabinet is very
dirty, dampen the cloth with a weak solution of neutral detergent and water, and then wipe clean.
Cleaning the Lens
A dirty lens may cause sound to skip. If the lens is very dirty,
the CD may not work. Open the disc cover and clean the
lens as follows:
For Dry Dust Particles
Using a camera lens brush/blower, blow on the lens a couple
of times, then wipe it lightly with the brush to remove dust.
Then, blow on the lens once more.
Finger Prints
If the lens cannot be cleaned using a brush/blower, use a dry cotton swab.
2