What You Will Need - DAC VS Recorder Quick Install Manual

Direct-wired Telephony Stations
Direct-wired telephony stations provide additional features to VS Recorder and do not require a
dedicated telephone line. This works by running dedicated wires from VS Recorder to the telephony station.
In addition, a junction box will be needed to interface between the station and the VS Recorder voice card.

- What You Will Need

A DAC digital dictate station of your choice
A DAC junction box
Cat3 ribbon cable to run from the station to the VS Recorder voice card
- Setup
The following steps presume you have already completed the basic installation of VS Recorder.
Step 1. Plug your dictate station's A/C adapter in.
Step 2. You may use either an ordinary telephone cable or make a custom one, preferably with Cat3
ribbon cable. Only 1 pair (the 2 middle wires) will be used. Plug the cable into the Data jack on the
dictate station.
Step 3. Run the other end of the cable to your junction box. Plug the cable into the Station 1 jack. This
will directly wire the station to VS Recorder's Channel 1.
Step 4. Run a telephone cable (single or double pair – doesn't matter) from the Port 1 jack on the
junction box to the Line 1 jack on the VS Recorder voice card.
Step 5. Verify that the switch for Station 1 on the front of the junction box is set to Loop.
Step 6. Plug the junction box's A/C adapter in.
Pg. 9
VS Recorder – Direct-wired Stations/Setup
visit us online @ www.dacsolution.com