DAC VS Recorder Quick Install Manual page 10

Step 7. Test your dictate station. You should hear a prompt for user ID when you log on.
If you are using more than one dictate station
You will follow all of the steps above, except for Step 4. The Station jacks on the junction box receive a
single-pair wire. The Port jacks on the junction box, though, output two pair, carrying the current from
both Station 1 & 2 (Port 1) or Station 3 & 4 (Port 2). However, the VS Recorder voice card only receives a
single pair on each Line jack. Thus, the current you are carrying in the two-pair wire from Port 1 must be
spliced into two, single-pair wires, and have new jacks crimped onto the end of the wire.
So, for example, when the telephone cable terminates into the Port 1 jack on the junction box, the
cable's two inside wires should be the pair going into Line 1. The two outside wires should be the pair going
into Line 2. The diagram above shows how to implement several dictate stations.
Pg. 10
VS Recorder – Direct-wired Stations/Setup
visit us online @ www.dacsolution.com