Table of Contents
Advertisement
C
OMPLIANCY
A G E N C Y I D E N T I F I C A T I O N N U M B E R S
Agency compliancy is a very important requirement for any product development. Laird Technologies has obtained
modular approval for its products so the OEM only has to meet a few requirements to be eligible to use that approval.
The corresponding agency identification numbers and approved antennas are listed below.
A P P R O V E D A N T E N N A L I S T
The following antennas are approved for use with the AC4868-250 as identified. The OEM is free to choose another
vendor's antenna of like type and equal or lesser gain as a listed antenna and still maintain compliance.
O E M E Q U I P M E N T L A B E L I N G R E Q U I R E M E N T S
WARNING: The OEM must ensure that the appropriate labeling requirements are met. Following are the requirements
for labeling equipment:
1
2
3
4
5
Downloaded from
Elcodis.com
electronic components distributor
I
NFORMATION
T a b l e 1 3 : A g e n c y I d e n t i f i c a t i o n N u m b e r s
Part Number
AC4868-250M
T a b l e 1 4 : A C 4 8 6 8 - 2 5 0 A p p r o v e d A n t e n n a s
Laird
Technologi
Manufacturer Part
es Part
Number
Number
0600-00020
S467-FL-6-RMM-868S
If the CE marking is reduced or enlarged, the proportions given in the following graduated drawing must be
respected.
The CE marking must have a height of at least 5 mm except where this is not possible on account of the nature of the
apparatus.
The CE marking must be affixed to the product or to its data plate. Additionally, it must be affixed to the packaging, if
any, and to the accompanying documents.
The CE marking must be affixed visibly, legibly, and indelibly.
The exclamation point must be included with the CE mark (as shown below) to alert the user to the fact that there are
restrictions placed on usage in certain countries. It must have the same height as the CE mark.
EUR/EN
Approved
Manufacturer
Type
Nearson
1/2 Wave Dipole
www.lairdtech.com
13
1
2
2
0
Gain
0
0
0
(dBi)
0
0
0
A
M
M
2
-
X
X
Advertisement
Table of Contents
