MN008301A01-AB
Chapter 3 : Operating Instruction
Status
Standby
End of Service
Life
Recalibration
Required
3.3
Installing the Cradle
Procedure:
1 Attach the RAM base to the cradle by tightening the four screws.
2 With the cradle attached to the RAM base, tighten the RAM mount with two screws onto the
vehicle bracket.
Figure 2: Cradle Installation
Label
1
2
14
LED Status
Flashing am-
ber
Alternating red
and green
Alternating
amber and
green
1
Description
Arm, accessory kit, RAM mount (HW003366A01)
Travel Charger/Vehicular Cradle (PS000498A01)
Comments
•
Battery is waiting to rapid
charge.
•
Battery may be too hot, too
cold, or low voltage.
•
Charger may be too hot.
Battery remains usable but may
be nearing the end of its rated
service life.
Battery requires calibration or
battery is due for calibration.
2