Table of Contents
Advertisement
3. Inspect spacers and mounting pins for wear and replace
as necessary.
4. Assemble flail knives (Fig. 14) as follows:
Starting at end of rotor, assemble a spacer and a flail
knife with hanger, then three more spacers.
Continue pattern until pin is full. Secure mounting
pin to rotor with roll pin.
1. Flail knife
2. Spacer
3
2
Figure 14
3. Rotor flange
Note: Count rotor flange as a spacer,
Rotate rotor 90 and continue assembly of next
section. Each section contains 4 knives, 4 knife
hangers and 10 spacers.
After completing full length of rotor, repeat
procedure on opposite side of rotor (180 ) from
initial assembly.
4. Mounting pin
11
5
4
1
5. Roll pin
Advertisement
Table of Contents
