14
English
6 Press the on/off button on the base station to turn on the product.
Select your desired mode (see 'Modes') and intensity (see 'Intensity
Settings').
7 Remove the handle from the base and point the tip of the nozzle into
the sink. Slide the pause switch on the handle to the 'on' (up) position
and wait until the water stream comes out of the tip of the nozzle. Stop
the flow of water by sliding the pause switch to the 'off' (down)
position.
Note: This step is for fist time use after purchase only.
8 Press the on/off button on the base again to turn off the product.
Using your Power Flosser
Make sure that the pause switch on the handle is in the 'off' position.
1
2 Press the on/off button on the base to turn on the product.