Duevi EZY-LAN Manual

EZY-LAN Wireless alarm panel with Ethernet + Wi-Fi + GSM + LTE
1 Identification of the parts
FRONTAL VIEW
1 – led power
2 – led Ethernet
3 – led Wi-Fi
12 8
BOTTOM VIEW VERSION HW 3B
12
8
BOTTOM VIEW VERSION HW 4A/4B
8 – button PWR
9 – button RJ45
10 – nanoSIM housing
4 – led GSM + LTE
5 – programmable central button
6 – multicolor led ring
10
9
11
9 10
11
11 – power supply input 12Vdc
12 –button PRT (internal)
EZY-LAN 22.01-M:3.0-H:3b/4a/4b-F:3.1.14+
2 Wall mounting
The control panel is equipped with a wall
mounting bracket, which also integrates the
housing for the anti-removal tamper magnet.
1
2
3
PLEASE NOTE
4
The anti-removal tamper function is
available starting from the HW 4B version
5
6
13
14
To mount, proceed as follows:
1. Use the bracket as a template for the holes
2. Drill two 5mm diameter holes on the wall at the
points (13)
3. (IF TAMPER PROTECTION NECESSARY)
Make a 6mm diameter hole 20mm deep on the
wall at point (15)
4. Fix the wall bracket with the supplied plugs
through the holes (13)
5. (IF TAMPER PROTECTION NECESSARY)
Insert the magnet supplied in the appropriate
hole in the bracket (15)
6. Insert the control panel on the bracket
matching the slots on the bottom with the
appropriate supports (14), then move the
control panel downwards until it stops.
13 - holes for wall plugs
14 – control panel supports
15 - hole for magnet (optional)
13
15
14