Going
For
A
Ride - QIWU Technology iGS630 User Manual

Use
two
rubber
bands
to
bypass
the
bike
stem
respectively,
hook
the
buckle

3）
of
the
bike
mount
and
fix
it
on
the
bike
stem.
4） Align
the
tabs
on
the
back
of
the
device
with
the
standard
bike
mount
notches.
5） Place
the
cycling
computer
on
the
base
and
rotate
it
90
degrees.
Note:
You
can
also
use
the
out-front
bike
mount
(iGPSPORT
M80)
to
install
cycling

computer.

It
is
recommended
that
you
use
the
official
standard
bike
mount
or
out-front

bike
mount
of
iGPSPORT
to
avoid
damaging
the
buckle
of
cycling
computer.

2.
GOING
FOR
A
RIDE

2.
GOING
FOR
A
RIDE
2.1
PRE-RIDING 2.1
PRE-RIDING
To ensure the accurate riding data, you need to wait for the device to detect the
GPS signal before riding.
If the GPS signal is needed, please go outside and keep away from tall buildings
and trees. Keep the device still and the screen up, and avoid touching it when
searching for GPS signal.
If the sensor has been connected to the device before, it will automatically
connect to the device once waken up, and the device will also automatically
search for the sensor. During your riding, the device will automatically measure
your heart rate, cadence and power and other data by using your sensors.
When the satellites for locating is four (minimum), the GPS icon shows








,
and
you
can

start
riding
at
this
time.
For
more
accurate
data,
please
wait
until







or







shows.
GPS

icon
becomes








when
enough
satellites
are
found
to
ensure
good
GPS
Gaccuracy.
After
all
signals
are
detected,
press







to
enter
the
cycling
data
page.
Press







to
view
the
riding
data
page.
Press







to
start
recording
an
activity
on
riding
data
page.
Press







to
start
a
new
lap
record,
and
the
lap
data
will
display
for
10
seconds.
Press







or







to
exit
the
popup
of
the
lap
data.
8