Cleaning And Maintenance - Midea MAR30-P0501GP Service Manual

Service manual for portable washer
Delay button: Press this button to set your desired delay time to start the unit for cycles.
Temperature button: Press this button to set your desired washing water temperature, hot, warm
or cold. The Hot and Cold LEDs will light if there is no LED for Warm setting.
Child Lock function: Press the two buttons together to activate this function. All buttons will be out
of function except the ON/OFF button. Press the two buttons together again to deactivate.
Wash button: Press this button to select washing time from 0 to 15 minutes. 0 selection will skip
the washing step.
Rinse button: Press this button to select rinsing times from 0 to 4 times. 0 selection will skip the
rinsing step.
Spin button: Press this button to select spinning time from 0 to 9 minutes. 0 selection will skip the
spinning step.

2.2 Cleaning and Maintenance

Cabinet:
The surface can be cleaned with diluted non-abrasive neutral detergents when necessary. If
there is any water overflow, use the wet cloth to wipe it off immediately. No sharp items are
allowed to strike the cabinet.
Internal tub:
Run an Express cycle with some bleach every month to clean the tub. This will also help to
remove mold which may occur inside the washer.
Dispose a Frozen Washing Machine:
When the temperature drops below zero and your washing machine gets frozen, you may:
1. Disconnect the power supply for the washing machine;
2. Wash the tap with warm water to loosen inlet pipe;
3. Take down inlet pipe and immerse it in warm water;
4. Pour warm water into washing basket and wait for 10 minutes;
5. Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally.
Anti-freeze:
If your washing machine is located in the room where it can get frozen easily, please drain the
remaining water inside drain pipe and inlet pipe thoroughly. Remove the remaining water in inlet
pipe and drain pump.
Water inlet valve filter
1. Screw off the inlet pipe from the machine.
2. Pull out the filter with pliers, clean it with water and reinstall it back after being washed.
3. Reconnect the inlet pipe.
4. Open the tap and make sure there is no water leakage.
5. Close the tap.
-------------------------------------------------------------------------------------------------------------------------------------------------------
－ 7 －
Midea America Company