Midea MAR30-P0501GP Service Manual page 27

Service manual for portable washer
8
Remove the top
cover
9
Replace the
control PCB
10
Replace the
Power PCB,
Door switch
11
Remove the
rear panel
12
Check the inlet
valve, water
level sensor,
safety switch.
-------------------------------------------------------------------------------------------------------------------------------------------------------
1
2
－ 27 －
Midea America Company
Remove the screws on the
front and back with Phillips
screwdriver.
For some models, the screws
fixing the top cover are on
the cabinet sides and backs,
not below the control box
including
MAE100-S2002GPS-M-13
and
MAM120-S2003GPS/M-13.
Open the control PCB box
with Phillips screwdriver.
Disconnect the terminals.
The control PCB is just in the
control panel.
Open the Power PCB box
with Phillips screwdriver.
Disconnect the terminals.
The Power PCB is under the
Top Cover.
The door switch is under the
top cover with harness.
Remove the two screws
fixing the Rear panel with
Phillips screwdriver
1: Water level sensor
2: inlet valve
3
3: safety switch