Midea MAR30-P0501GP Service Manual page 17

Service manual for portable washer
Water leaks Hoses not installed correctly.
every load
Washer will Water supply is turned off.
not operate Control panel has powered off
due to inactivity.
Washer is unplugged.
Controls are not set properly.
Lid is open.
Circuit breaker/fuse is
tripped/blown.
Control needs to be reset.
START/PAUSE was not
pressed after a cycle was set.
Extremely low water pressure.
Washer is too cold.
Washer is running under Delay
start program.
Washer not Filter clogged.
filling properly Inlet hoses may be kinked
Insufficient water supply.
The washer lid is open.
Hot and cold inlet hoses are
reversed.
Water level is too low.
-------------------------------------------------------------------------------------------------------------------------------------------------------
Check all fi ll and drain hose connections to
ensure that they are tight and secure.
This is normal. Press the POWER button to turn
the washer on.
Make sure cord is plugged securely into a
working outlet.
Turn both hot and cold faucets fully on.
Make sure the cycle was set correctly, close the
lid and press the START/PAUSE button.
The washer will not operate if the lid is open.
Close the lid and make sure that nothing is
caught under the lid preventing it from closing
completely.
Check house circuit breakers/fuses.
Replace fuses or reset breaker. The washer
should be on a dedicated branch circuit. The
washer will resume the cycle where it stopped
once power is restored.
Press the POWER button, then re-select the
desired cycle and press the START/PAUSE
button.
Press the POWER button then re-select the
desired cycle and press the START/PAUSE
button. The washer will shut off if the
START/PAUSE button is not pressed within ten
minutes.
Check another faucet in the house to make sure
that household water pressure is adequate.
If the washer has been exposed to
temperatures below freezing for an extended
period of time, allow it to warm up before
pressing the POWER button. Otherwise, the
display will not come on.
It's normal if the unit doesn't operate under
Delay start function. It will start automatically
after the delay time is out.
Disassemble the water inlet hose and clean the
inlet point. Check that inlet hoses are not kinked
or clogged.
Make sure that both hot and cold water faucets
are turned on all the way.
The washer will not operate if the lid is open.
Close the lid and make sure that nothing is
－ 17 －
Midea America Company