Page 1
Use Liquid Thread Locker Washer M5 SRC Design uses Metric System of Measu reme nt and all dimensions in Millimeters * Recommended to use the Torque specified in the table **Deno tes Usage of Liquid Thread Locker in specified Locations...
Page 2
Mounting End hole and Slip-in Screw M8 x 65 (15) – 1 off and Taper Ring M8 (11) – 1 off, and slip-in the screw M5 x 15 (13) - 4 off , washer M5 (16) - 4 off ,through the holes and secure the threads. Copyright By SRC Design and Specification are subjected to change Page 2...
Page 3
Step 4: Repeat the above step for the other side to secure the threads. Step 5: Mounting Set Oil ! Copyright By SRC Design and Specification are subjected to change Page 3...
Page 4
Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle, Part and its functional aspects. 3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part. It is advised to the User, to inspect and ensure the original state of all other Vehicle parts.