Mediroyal NrX STRAP Quick Start Manual

Stable Wrist Wrap
Material NRX
1
Cut a 35-40 cm length of the NRX
cut a hole for the thumb, off center. Under the thumb hole you cut a curve.
The space between the top of the curve and hole should be 15-25 mm. Cut a
shaped curve from the 10-15 mm from the top of the hole and angle it towards
the end of the strap on one side. Do the same on the other side but keep this
part slightly wider. Splint the end of that part.
3
Apply the narrow strap that goes on the dorsal side around the wrist and secure
it again on the dorsal side.
Caring instructions
The NRX ® strap can be washed in 40 degrees machine wash with a liquid
detergent. Always use a laundry bag. Remove the hook parts before washing
and let air dry.
Mediroyal Nordic AB · Box 7052 · 192 07 Sollentuna · Sweden · Tel +46 8 506 766 00 · info@mediroyal.se · www.mediroyal.se
110 mm + 2 hook tabs
®
110 mm strap. In the middle of the strap,
®
© Mediroyal Nordic AB 2018
– One strap, unlimited options!
2
Position the thumb through the
hole and let the wider part of the
strap run over the volar side.
4
Wrap the wide part on the volar
side around the wrist. You might
have enough material to do two
turns. It that feels too bulky, simply
trim the length of the strap.