Onkyo TX-DS656 Instruction Manual page 47

Multi-room system connections
Models other than U.S.A. and Canadian models (Onkyo Multi-Room Systems)
Do not plug in the power cord until all connections have been made.
When making connections 1 through 4, be sure to connect the units as shown in the connection diagram below. Do not make a mistake when
connecting the units.
A. Operating components displaying Onkyo's z mark from the sub-room
Components mounted in a rack should be connected as shown below to enable remote control operation.
MAIN ROOM
1. Onkyo components (a)
TX-DS656
Main Main
speaker speaker
B. Using a remote controller to operate components not displaying Onkyo's z mark from the sub-room
3. Remote Emitter
MAIN ROOM
HE-50(AC)
Power
supply
4. Components(c)
TX-DS656
Main
speaker
Connection diagram
MAIN Speaker (Main Room)
R L V
OUT
VIDEO-1
ANTENNA
IN
OUT
VIDEO-2
AM
IN
FM
75
DVD
IN
FM
300
MONITOR
(REC) V
OUT
TAPE-1
(PLAY) IN FRONT
R L
CD R L
(REC)
SURROUND
OUT
R L
GND IN
(PLAY)
PHONO TAPE-2 CENTER SUBWOOFER
R L R L PRE OUT
Remote
control
2. Remote
speaker
5. Remote Emitter
Head HE-10
Remote control
1. Components(b)
Main
speaker
MJ
27122482
CENTER
S SURROUND SPEAKERS
SPEAKER
OUT FRONT
R L
R L
IN SURROUND
R L MULTI
CHANNEL
OUT INPUT
CAUTION: SPEAKER IMPEDANCE
CENTER SUBWOOFER
IN
DIGITAL INPUT
R L
IN DIGITAL 1
(OPTICAL)
DIGITAL 2
OUTPUT (COAXIAL) FRONT REMOTE SPEAKERS
S
DIGITAL 3
(COAXIAL)
REMOTE CONTROL
IN
OUT
WARNING AVIS
RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE
DO NOT OPEN NE PAS OUVRIR
TX-DS656
SUB-ROOM
3. Remote sensor
HR-10
2. Remote
speaker
SUB-ROOM
Remote sensor
HR-10
Remote Remote
speaker speaker
Remote Emitter
3
FRONT MAIN SPEAKERS
R L
2
6 OHMS MIN. / SPEAKER
REMOTE Speaker
(Sub-room)
AC OUTLETS
AC 120V 60Hz
SWITCHED
TOTAL 120W 1A MAX.
1
1. Set up the components (a) displaying
Onkyo's z mark.
2. Connect the sub-room speaker cables to the
FRONT REMOTE SPEAKERS connectors
on the TX-DS656. (1)
3. Install Remote Sensor HR-10 in the sub-
room, then connect it to the TX-DS656. (2)
1. Connect the components (b) to the TX-DS656.
2. Make the connections described above in
steps 2 through 3 of section A.
3. Install Remote Emitter HE-50 (AC) so that
its sensor is directed toward these compo-
nents, then connect it to the TX-DS656. (3)
(Connect the AC adapter to the Remote
Emitter.)
Operating components which are positioned
out of the range of the emitter installed as
described above.
4. Connect the components (c) to the TX-DS656.
5. Install Remote Emitter Head HE-10 so that
its sensor is directed toward these
components, then connect it to the HE-50
(AC). (4)
AC adapter
4
Remote Sensor
SUB-ROOM
47