Connecting Other Components; Operation - Onkyo DX-7333 Instruction Manual

Connecting other components

•
Do not plug in the AC power cord until all other connections have been made.
•
For output jacks, the jack marked R corresponds to the right channel, and the jack marked L to the left channel. Refer to the
amplifier's instruction manual for further information on connections.
•
Avoid bundling the audio connection cables with the power cord or speaker cables. Doing so may degrade sound reproduction.
•
Insert the plugs and connectors securely. Remember that improper connection can result in noise, poor performance, or dam-
age to the equipment.
Improper
connection
Insert
completely
Audio connection cable
L R
CD jack jack
Amplifier without
digital inputs
A
Connection with the amplifier
Connect the DX-7333 to the CD jacks of your amplifier.
B
Connection via the digital output jack (DIGITAL
OUTPUT OPTICAL)
Connection to digital equipment, such as an MD recorder or
DAT.
Use an optical cable to connect this unit to the digital input
(optical) jack of an MD recorder or DAT in order to make dig-
ital recordings. The optical cable should have connectors
which fit into the digital jacks.
C
Connections for remote control
When the DX-7333 is connected to an amplifier with the Onkyo
jack, pressing the CD operation button on the amplifier's
remote controller enables you to operate the CD player.
Note:
•
The upper and lower
same function.
•
Remote control operation is not possible when only the
remote control cable is connected – the audio cables must
also be connected.
•
An cable equipped with a 1/8" (3.5mm) diameter min-
iature two-conductor phone plug is included with the DX-
7333 and with every tuner or cassette tape deck with the
symbol.
6
Protection caps are attached to the DIGITAL OUTPUT OPTICAL
jacks. Remove the cap for the jack you wish to use when connect-
ing the DX-7333 to digital equipment. Replace the caps if you are
not using the DIGITAL OUTPUT OPTICAL jacks.
ANALOG
DIGITAL OUTPUT
OUTPUT
REMOTE
OPTICAL CONTROL
L
R
1
2
cable
Optical fiber cable
(not included)
OPTICAL IN jack
MD player, DAT, etc.
with digital inputs
remote control jacks have the
COMPACT DISC PLAYER
DX-7333
MODEL NO.
2-1, NISSHIN-CHO, NEYAGAWA-SHI,OSAKA,
JAPAN MANUFACTURED IN MALAYSIA
3
Connecting an Onkyo product
with connectors enables you
to use the System function.
OPTICAL IN jack
Amplifier, Tuner amplifier,
etc. with digital inputs
ONKYO
D
Connecting the AC power cord and turning the
power on
1. Insert the AC power cord into a wall outlet.
2. Press the POWER button.
The display will light.
WARNING AVIS
RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE
DO NOT OPEN NE PAS OUVRIR
4
To AC outlet
TUNER
DX-7333
AMPLIFIER
TAPE DECK