Hisense WFMC6010E User's Operation Manual page 30

If the laundry is still too wet at the end of the cycle, remove some articles of
laundry and repeat the spin cycle.
Excessive foam formation may prevent spinning. Use the correct amount
of detergent.
Check that the spin speed selector has been set to "
Ensure that:
All connections are tightly fixed.
Do not allow children to operate, crawl on, be near or inside your washer.
Note that during the wash cycles, the surface temperature of the porthole
d o o r m a y increase.
Close supervision of children is necessary when the appliance is used near
children.
Error code
The appliance stops during the programme.
The error code will apper with some lights.
means the light is on;
Door lock is abnormal(F13): The indicator will light up.(fig.1)
Check whether the door is closed or not and press the "start/pause" button;
if the fault persists, unplug the appliance and contact After-Sales Service
(see "After-Sales Service").
Drainage fault(F03):(fig.2)
Waste water is not being pumped out.
The washing machine stops in the appropriate programme step.
Unplug the appliance.
Check whether:
Kinks are present in the drain hose;
The pump or the filter is blocked (see "Removing the Filter").
IMPORTANT:
Ensure that
means the light is off .
the water has cooled before drainning the appliance.
".
fig.1
27