Connecting The Water Supply - Hisense WFMC6010E User's Operation Manual

Step 3: Important:
appliance casing.

4.5 Connecting the water supply

Notes:
Connect the water supply inlet hose in accordance with the regulations
of your local water company.
Water tap: 3/4'' threaded hose connector
Water pressure (flow pressure): 100-1000KPa(1-10 bar).
Only use a new inlet hose for connecting the washing machine to the
water supply. Used hoses must not be reused. They should be discarded.
Step 1:
If the water inlet hose is not already installed, it must be screwed to the
appliance The blue marked hose is only for cold water. Depending on
the model, the hot water hose marked with red should also be connected,
for models having dual inlets.
Step 2:
Screw by hand the inlet hose onto the tap, tightening the nut.
Attention:
No kinks in the hose!
The appliance must not be connected to the mixing tap of an un-pressurized
water heater.
Check water-tightness of connections by turnning the tap completely on.
If the hose is too short, replace it with suitable lenght of pressure resistant
hose (1000 kPa min, EN 50084 approved type).
tighten the locknut by turning it anti-clockwise towards the
9