Advertisement
CERAMIC TOWER HEATER
Thank you for purchasing your new heater.
These operating instructions will help you use it properly and safely.
We recommend that you spend some time reading this instruction manual in order that you
fully understand all the operational features it offers.
Read all the safety instructions carefully before use and keep this instruction manual for
future reference
Email: service@sundaylivinginc.com
MODEL.: PTC-1503D-NO2-1
Facebook: #SundayLiving
Message: #SundayLiving
Advertisement
Table of Contents
Related Manuals for Sunday Living PTC-1503D-NO2-1
Summary of Contents for Sunday Living PTC-1503D-NO2-1
- Page 1 CERAMIC TOWER HEATER MODEL.: PTC-1503D-NO2-1 Thank you for purchasing your new heater. These operating instructions will help you use it properly and safely. We recommend that you spend some time reading this instruction manual in order that you fully understand all the operational features it offers.
- Page 2 INTENDED USE This product is intended for indoor residential and office use only, not for industrial or other commercial application. Use only with electrical wiring that is in good working order and that meets applicable codes and ordinances. This heater must be plugged into a 120V AC circuit.
- Page 3 This heater is not designed as a primary heat source. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip). Always unplug heater when not in use. Do not run power cord under carpeting.
- Page 4 FUNCTION INTRODUCTION Standby mode Plug in the power, turn on the power switch, the display screen shows the ambient temperature, the product standby. ON/OFF button Press ON/OFF button for the first time, the product will be powered on and the air supply indicator will light up.
- Page 5 light can be turned off.Long press the rotary key for three seconds to turn off the screen or turn off the light, and press any key to wake up.After power on again, the above should be pressed again. REMOTE NOTE: Please feel free to contact Service Team for help if the remote control is missing or damaged.
- Page 6 1. POWER Switches on I off the heater or stand by 2. Heating Mode Press the heating button, there are 1000/1500W heating setting for you to choose. 3. Temperature Setting The temperature can set between 60-95 degrees Fahrenheit. 4. Oscillation Setting Press the oscillation setting button, the heater will start to swing from side to side.
- Page 7 WARNING DO NOT let liquid enter the heater. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater. DO NOT immerse the heater in water. ...
Need help?
Do you have a question about the PTC-1503D-NO2-1 and is the answer not in the manual?
Questions and answers