Dometic D+ Assembly, Installation And Operating Manual page 10

Setting up the device
After the device is connected, it is automatically detected the operational voltage (12 V or 24 V).
Meanwhile, the LED blinking red and green alternately. When the LED blinking only red, the
device is ready to use.
8.2 Switch-off delay settings
The switch-off delay specifies how long the D+ signal is maintained after switching the engine off.
I
NOTE
If the switch-off delay is selected appropriately, the D+ signal can be prevented from
being unintentionally switched off on vehicles with an automatic start-stop system.
➤ To set the required switch-off delay, turn the rotary switch to the corresponding position
(fig. 2, page 4, 2).
.
Position
1
2
3
4
5
6
7
8
9
10
11
8.3 Voltage detection setting
When the voltage detection is active (factory default) the device is controlled by vibration and volt-
age. The D+ signal switches on when the engine is running and the starter battery voltage has
reached at least 13.7 V (or 27.4 V) for min. 4 s. After the D+ signal switching on, the voltage may
drop back below this threshold the device is controlled purely by vibration again.
➤ To set the additional voltage detection, the rotary switch must be in the "Setup" position.
✔ If the device is in setup mode, the LED is blinking yellow.
➤ Turn the rotary switch quickly three times from the leftmost to the rightmost position and back
to switch on or off the voltage detection.
✔ If the LED is blinking green the voltage detection is turned on successfully.
10
Switch-off delay
Setup
No function
10 s
15 s
30 s
60 s (Factory default)
90 s
2 min
3.5 min
5 min
No function
D+ Active Simulator
EN