Supervisor Audio With Srx2/Srx3 Headsets; Enabling Supervisor Audio - Honeywell SRX2 User Manual

SrxClearPairingInCharger set to 0 in order to maintain pairings through device
reboots and recharging.
Q: Our users are spending a lot of time pairing. What methods would you
recommend to reduce the time it takes to pair headsets?
A: There are a number of solutions:
l
l
l
l
l
l

Supervisor Audio with SRX2/SRX3 Headsets

Supervisor Audio is a feature that will allow a second party to listen to the
conversation between a Bluetooth-enabled device and a user with an
SRX2/SRX3 headset.
A supervisor wears a wired headset connected to the operator's device, then
walks behind the operator who is wearing a wireless headset paired with the
same device. The supervisor must keep the operator's device within range of the
operator's wireless headset.
Supervisor Audio offers two listening modes.

Enabling Supervisor Audio

To enable this feature, set the SrxSupervisorAudioEnable configuration
parameter to the desired mode.
47
Use a pairing mode that is not as susceptible to cross pairing - avoid using
auto pairing.
Ensure that users are isolated by some distance when the devices perform
inquiry searches.
Use manual pairing, rather than auto pairing, so that the searches are done
only at the user's request.
Use low power pairing.
If your users do not share headsets and devices, use manual pairing so that
the device and headset remain paired.
If your users share headsets and devices, use auto pairing so that pairing
hardware at each shift will complete faster.
NOTE
This feature is designed to work with Vocollect Talkman devices. It may
function properly with other devices depending on the available processing
power. See the release notes for Vocollect Voice software and your device.
Combined audio - the user's microphone audio and the
l
text-to-speech (TTS) audio are combined and streamed out
of the wired audio port
Device audio only - the TTS audio only is streamed to the
l
second party
SRX3 User Guide - Preliminary