Adjust Headset For Comfort; Clean Headsets - Honeywell SRX-SL User Manual

3. Make final adjustments with the boom so that the microphone is positioned
correctly. Position the microphone as close to your mouth as possible, but
outside of your breath stream. It should be facing your upper lip, and not
touching anything (for example, clothing, skin, or facial hair). There are three
notches at the lower range of the microphone boom swing. Select the one
that best places the microphone near the mouth.
4. Pair the SRX-SL Headset Using Bluetooth

Adjust Headset for Comfort

Honeywell has designed the SRX-SL headset based on data for most head shapes and sizes. Because the headset is the
most personal piece of voice equipment and must remain stable while workers perform very physical tasks, users may ben-
efit from these headset adjustment guidelines.
• Placement of the "T-bar" pad: The SRX-SL headsets have pads called "t-bars" opposite the speaker side of the
headset. The t-bar should be positioned on a part of the head with the least amount of muscle.
As an operator speaks, the muscle above the ear flexes. If the t-bar is placed on this muscle, the headset applies pressure to
the artery and nerves beneath it and can cause the operator some discomfort. The operator can locate this muscle by mov-
ing his or her jaw and feeling the area above the ear for movement. Some operators choose to alternate the headset position
on either side of their heads during their shifts.

Clean Headsets

The foam pads used with Honeywell headsets were designed for both comfort and hygiene. The materials naturally inhibit
the growth of bacteria and can be cleaned by rinsing with water and drying.
Note: Commercial cleaning solvents are not recommended.
• Clean the plastic parts of the headsets with a soft cloth dampened with water. To clean and disinfect the headset plastic,
use a pre-moistened alcohol wipe.
• Do not use unapproved liquids to clean the headset.
2 - 6
(see page 2-2) to the device.