Olympus CAMEDIA D-100 Reference Manual page 92

92
TROUBLESHOOTING
When the monitor cannot display images
Cause
The camera is in the shooting mode.
No image has been saved on the card
in use.
The digital camera is connected to a
TV.
There is a problem with the card.
When image protection, single-frame erasure, all-frame erasure or formatting is impossible
Cause
A write protect seal is attached to the
card.
When an error message is displayed during data downloading to the connected PC
Cause
The cable is not connected properly.
The camera is off.
The battery power is low.
The USB driver is installed incorrectly
in your PC.
Remedy
Close the lens barrier and press the
monitor button so that the monitor turns on and
displays an image.
The display shows message "NO PICTURE".
Note that playback is possible only after images
are shot.
The monitor turns off while the camera is
connected to a PC.
Check the error message.
Remedy
Remove the seal. Note that the removed seal
should not be reused.
Remedy
Check that it is connected properly.
Press the monitor button to turn the cam-
era on.
It is recommended to use the AC adapter
(optional) when the digital camera is connected
to a PC.
Observe instructions given in the installation
manual of the USB driver and make sure that the
camera is recognized by your PC.
See
P. 42
P. 42
P. 89
P. 71
P. 89
See
P. 25
See
P. 81
P. 30
P. 70
P. 81