Amendments and approval of this document can only be carried out by the relevant people listed on the Approved list of signatures, which is listed in the Apeks quality Manual. To instigate a change, a Task / Change request form, (Form No.
Method damaged or the hose is maintenance and repair of the Apeks Flight first stage regulators. it hoses are secure in the hose crimps. pulling out of the crimp press upwards on...
Page 4
1st Stage into a vice. using the gently pull out. With the Flight First Stage secured in a vice using the work diaphragm clamp tool pn At71 and a 3/8” drive socket handle tool (pn At48), fit the yoke connector tool (pn wrench carefully unscrew the Composite diaphragm clamp At74) and a long 6mm allen/hex socket.
Sealing faces, grooves and bores should be checked insert the valve Lifter (8) into the Flight Body (9). place the for scratches. inspection should be performed in a well Splitter (7) into the Flight Body (9) locating the round leg lit area.
Page 6
Bolt (24) engaged in the Knob. turn the yoke Knob (35) until the Carefully insert the hp valve (16) into the Flight Body (9) hex Axle (36) protrudes through the yoke Clamp (31) so making sure that it slides onto the shaft of the valve Lifter that the plastic Clip (30) can be fit into the groove on the (8).
Page 7
FLIGHT First Stage Regulator Maintenance Manual FLIGHT First Stage Regulator Maintenance Manual Assuming there are no leaks, close the cylinder valve and WArning: Compressed air can be highly explosive depressurise the regulator by opening the gauge relief and is dangerous if misused. ensure cylinder valve is valve or by pressing the purge button of the second stage opened slowly.
Page 8
FLIGHT First Stage Regulator Maintenance Manual FLIGHT First Stage Regulator Maintenance Manual table 1 - troubleshooting guide table 2 - recommended tool List SyMptoM poSSiBLe CAuSe treAtMent pArt no. deSCription AppLiCAtion 1. hp valve (16) is worn or damaged. 1. replace hp valve.
In addition, each regulator design has passed stringent adiabatic compression testing to ensure its safety and compatibility with increased percentages of oxygen. If it is your intention to use your new Apeks regulator with Nitrox EAN (O2 not to exceed 40%), it is imperative that you maintain the internal cleanliness of the regulator (see section on Care and Maintenance).
Page 10
FLIGHT First Stage Regulator Maintenance Manual FLIGHT First Stage Regulator Maintenance Manual FLight yoke exploded parts diagram table 4 - torque Specifications pArt nuMBer deSCription / Key nuMBer torQue Ap5761 din Connector (21) 25 nm / 18.4 lbf/ft note: item 5 is no longer used.
Page 11
FLIGHT First Stage Regulator Maintenance Manual FLIGHT First Stage Regulator Maintenance Manual FLight M26 nitrox exploded parts diagram FLight din exploded parts diagram note: item 5 is no longer used. discard this part. note: item 5 is no longer used. discard this part.
Need help?
Do you have a question about the Flight and is the answer not in the manual?
Questions and answers