Advertisement
7
2.4 Modbus RTU Interface and wiring
1. 2 LEDs for communication state display (TxD and RxD)
2. 2 LEDs for termination state display
3. Allocation of signal name
4. 5-pin terminal block for communication interface
The Modbus-RTU can be connected to up to 5 ABB drives via the following connections:
Terminating resistors
120 Ω ¼ W is required at both line ends of the Modbus-RTU network
The VFD-GATEWAY has Built in 120 Ω resistor that is enabled from the factory; the VFD-GATEWAY must be at
the beginning/end of the network at not mid-network.
The user must also turn on termination resistor at the end of line node (see specific drive manual for
information).
Status LEDs:
TXD - YELLOW - ON (blinking) - transmitting
RXD - YELLOW - ON (blinking) - receiving
120R - YELLOW - ON - Bus termination
PUD- YELLOW - ON - Pull up/pull down
(This VFD-GATEWAY has built in Bus Termination and Pull Up/Pull down resistors
When yellow lights are lit. bus termination resistor is activated or the pull up/pull down resistors are activated)
LVD-EOMU02U-EN REVB 04/2022
Advertisement
