Yamaha Clavinova CLP-970 Service Manual page 13

[83]
[83]: Bind Head Tapping Screw-1 3.5X14 MFZN2BL (EP030250)
(Fig. 15)
FDD Cover
[9]
[3]: Bind Head Screw 3.0X5 MFZN2Y (EG330150)
[9]: PW Head Tapping Screw-B 3.0X8-8 MFZN2Y (V2276900)
(Fig. 16)
[S2]: Truss Head Screw 4.0X12 MFZN2BL (VP367300)
[S4]: Truss Head Screw 4.0X20 MFZN2BL (03747290)
(Fig. 17)
[4a]
Speaker
[4]: PW Head Tapping Screw-1 4.0X16 MFZN2BL (EP040250)
(Fig. 18)
CLP-970/CLP-970M/CLP-970C/CLP-970A/CLP-970AM/CLP-970AC
[83]
FDD Ass'y
Holder, FDD
[3]
[S2]
Back Board
[S4]
[4b]
Speaker
11 FDD Assembly
11-1 Remove the six [6] screws marked [83]. The FDD
assembly can then be removed. (See Fig. 15)
11-2 Remove the four [4] screws marked [9]. The FDD
cover can then be removed. (See Fig. 16)
11-3 Remove the four [4] screws marked [3]. The holder
FDD can then be removed. (See Fig. 16)
* Model equipped with "A" has no floppy disk drive.
12 Back Board
Remove the two [2] screws marked [S2] and the
four [4] screws marked [S4]. The back board can
then be removed. (See Fig. 17)
13 Speaker
13-1 Remove the music rest assembly. (See procedure 1.)
13-2 Remove the keycover assembly. (See procedure 5.)
13-3 Remove the four [4] screws marked [4a]. The 13cm
speaker can then be removed. (See Fig. 18)
13-4 Remove the three [3] screws marked [4b]. The 2.5cm
speaker can then be removed. (See Fig. 18)
* The left speaker and right speaker can be removed
in the same manner.
14 Main Unit
14-1 Remove the back board assembly. (See procedure 12.)
14-2 Disconnect the AC cord.
14-3 Disconnect the PK cable.
14-4 Remove the four [4] screws marked [S3]. Lift the
main unit up slightly and then slide it to backward
and then lift it up. (See Fig. 19)
* Be sure to place your hands at least 15cm from
either end of the main unit and take care not to
pinch your fingers when removing it.
Bottom face of the Keybed
AC Cord
[S3]: Truss Head Screw 6.0X25 MFZN2BL (VQ448400)
(Fig. 19)
[S3] x 4
13