Table of Contents
Advertisement
CAUTION
6.9
When power is turned off, or a power failure has occurred, the Blue LED lights
on the key pad, will flash ON and OFF, when the power is restored.
To restart the pump press the green start button
default (L/Hr) setting and then adjust the manual capacity button
specific requirements.
6.10
To reset the default (L/Hr) setting.
6.10.1 Stop the motor
6.10.2 With the LED lights flashing press the up arrow
"P051".
6.10.3 Press ok
6.10.4 Press the up or down arrows
6.10.5 Press ok
6.10.6 Press the start button
Note:
1/ Do not set the "Default" P051 to zero (0).
2/ The blue LED readout is only associated with the manual adjustment and it
does not change when the pump is operated from a 4-20mA input signal.
The Manual Capacity Adjustment Panel
side of the motor.
This unit can also be mounted remotely. For remote mounting the cable length must
not exceed 15 metres.
Note:
1/ The programming parameters for your pump have been pre-set and do not need
any adjustment.
2/ Wiring of the pump is as per the wiring drawings section 12 of this manual.
Acro-Smart Electronic Series
and the Blue LED lights will flash ON and OFF.
.
to the desired default flow rate.
to enter the new setting.
.
January 2017
to restore the preset
until the LED's reads
is normally located on the
Acro-Smart Electronic Series
to your
Advertisement
Table of Contents
