Safety Notes - Fahrenheit 28022 User Manual

EN
User Manual
s n
afety
• Tip is hot. Do not touch.
• Place the heated soldering iron on a heatproof work bench.
• After finished using the soldering iron, cool the iron naturally.
• Do not immerse in water!
• Always place the soldering iron on the stand when not in use.
• If the cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety.
o
perating
• Check that the voltage on the tool is same as source of current.
• Make sure iron tip is in fixed position and screw is tightened.
• Connect soldering iron to mains current.
• Surfaces of the connection points must be clean.
• "Tin" the tip by covering the heated tip with rosin core solder.
• Use the soldering iron to heat the connection points, not the solder.
• Apply only enough solder to the heated parts.
• Allow the joint to cool undisturbed.
• Clean the tip with a wet sponge while the tip is still heated.
• This tool allows you to operate in standard mode for normal soldering
or Thermal Boost mode for fast heat up.
• Press the trigger at the handle to switch to Thermal Boost mode which
is designed to give quick burst of added power when you need it.
• After 15 seconds, please switch back to standard mode by releasing
the trigger to prevent the gun from overheating while in Thermal
Boost mode.
• This tool must return to standard mode for 45 seconds before
activating to Thermal Boost mode again.
• Unplug the soldering iron and let the iron cool down naturally.
otes
i
nstrUction