Advertisement
|
LEAKSAFE SOLUTIONS
WATERSWITCH3 INSTALLATION INSTRUCTIONS
1.5.3 Installing batteries and enrolling a Wireless On/Off Switch
1. Slide backplate of wireless switch down to release the catches. Insert a
small flat bladed screwdriver into the openings on the left of the switch
and turn gently, the cover will separate from the backplate.
2. Install the 2 x CR2032 batteries in the wireless switch.
3. Press and hold 'ENROL' on the Water Valve Control until yellow
'WARNING LED' lights, release then press 'ENROL' and release again,
and the green 'VALVE OPERATING LED' will start to flash.
4. Make sure there is at least a 2M distance between the Valve Control and
the Wireless Switch.
5. Press and hold the 1h button on the wireless switch until the green light on
the switch flashes, release and press 1h again then press 'ON' to send the
enrol signal. The Water Valve Control will start to beep. Press 'ON' on the
valve control to accept the enrol command.
6. Press 'OFF' on the wireless switch to exit enrol mode on the switch and
press 'OFF' on the Water Valve Control to stop enrol mode on the Control.
1.5.4 Testing the Wireless On/Off Switch
1. Ensure the wireless On/Off switch is at least 2 metres away from the Water Valve Control. Press the 'OFF' switch. The blue LED
indicator on the switch will flash, the Water Valve Control will beep twice to confirm a wireless signal has been received, and
the wireless switch will flash red and beep twice to confirm that the command has been acknowledged. The valve will close.
2. Press the 'ON' switch. The blue LED indicator on the switch will flash, the Water Valve Control will beep once to confirm a
wireless signal has been received, and the wireless switch will flash green and beep once to confirm that the command has
been acknowledged. The valve will open.
1.6 Deleting the Water Valve Control memory
This will clear ALL enrolled wireless devices – wireless leak detector transmitters and wireless On/Off switches and reset the
Default Settings and Continuous Flow or No Flow settings to factory default (see Sections 1.2 & 1.3).
1. Press and hold down the 'OFF' button until the red 'LEAK ALARM LED' lights, release and press 'OFF' button again. The Water
Valve Control will beep 3 times to confirm that it has returned to factory default settings.
PAGE 6
Wireless On/Off Switch
with delay function
Advertisement
