Advertisement
|
LEAKSAFE SOLUTIONS
WATERSWITCH3 INSTALLATION INSTRUCTIONS
1.3 Water Valve Control – FLOW OR NO FLOW VALVE AUTO CLOSE (Requires installation of a Flow Meter).
Set using the DIP switches and Setting Button (Figure 1) and with reference to the tables below.
SET THE ALLOWED CONTINUOUS FLOW TIME LIMIT
Set DIPs 1, 2 & 3 to set the amount of time water may flow
continuously before the Valve closes
Time
30 minutes (Factory default)
1 hour
1.5 hours
2 hours
4 hours
6 hours
OFF
Engineer use*
If set time is exceeded the valve will close and the Water Valve
Control will alarm.
*Valve size 20mm – 42mm: 5 minute engineer test. Valves 54mm +: 20 minute engineer test
Once the DIPs are set, press the Setting Button and then IMMEDIATELY release. The Water Valve Control will beep once to confirm
that the settings are stored in memory.
Reassemble Water Valve Control.
1.4 Initialising the Water Valve Control and testing the Valve Open & Close functions
WARNING: Do not insert fingers or any other object into the valve whilst it is operating.
1. Ensure a Valve is connected to input 'V' on the bottom of the Water Valve Control.
2. Press the 'WATER ON' button it beep once. The green 'VALVE OPERATING LED' will flash for 10 seconds.
3. When the 'VALVE OPERATING LED' stops flashing, press the 'WATER OFF' button it will beep twice. The green
'VALVE OPERATING LED' will flash for 10 seconds, and the valve will close.
4. Press the 'WATER ON' button to re-open the valve.
DIP 1
DIP 2
DIP 3
0
0
0
1
0
0
0
1
0
1
1
0
0
0
1
1
0
1
0
1
1
1
1
1
0 = OFF / 1 = ON
SET THE ALLOWED NO FLOW TIME LIMIT
Set DIPs 4, 5 & 6 to set the time delay before the Valve closes
when no water flow is detected
Time
6 hours
12 hours
18 hours
24 hours
36 hours
48 hours
OFF (Factory default)
Engineer use*
If set time is exceeded the Valve will close but the Water Valve
Control will NOT alarm.
PAGE 4
DIP 4
DIP 5
DIP 6
0
0
0
1
0
0
0
1
0
1
1
0
0
0
1
1
0
1
0
1
1
1
1
1
0 = OFF / 1 = ON
Advertisement
