Connecting To Another Pc In Ad-Hoc Mode; How To Configure An Ad-Hoc Mode Profile - NETGEAR RangeMax WPN311 User Manual

You can check the status bar in the configuration utility for the current connection status.
Note: If you cannot connect, see the
have problems accessing network resources, the Windows Client and File and Print Sharing
software might not be installed and configured properly on your computers. Please refer to
"Preparing Your Computers for TCP/IP Networking" on page

Connecting to Another PC in Ad-Hoc Mode

The computer-to-computer setting of the WPN311 uses Ad-Hoc mode. Ad-Hoc mode is an 802.11
networking framework in which devices or computers communicate directly with each other,
without the use of an access point. For example, this mode is used when two Windows computers
are configured with file and print sharing enabled and you want to exchange files directly between
them.

How to Configure an Ad-Hoc Mode Profile

Note: Ad-Hoc mode will not work using DHCP settings. Ad-Hoc mode requires either static IP
addresses (such as
192.168.0.1)
parameters such as adding IPX protocol support. For instructions on setting up static IP addresses
or IPX protocol settings on a Windows PC, refer to the PC Networking Tutorial included on the
NETGEAR RangeMax™ Wireless PCI Adapter WPN311 Resource CD.
Follow the instructions below to configure an Ad-Hoc mode profile.
1. Run the WPN311 Configuration Utility.
a. Open the configuration utility by clicking on the WPN311 icon
system tray.
C on figu ra tion
User Manual for the NETGEAR RangeMax™ Wireless PCI Adapter WPN311
"Basic Troubleshooting Tips" on page
or other appropriate Windows networking configuration
3-12. Also, if you
C-1.
in the Windows
4 -5