Advertisement
Software Requirements
Swipe card in the swipe channel from top to bottom.
If employee card number is successfully read, the time clock terminal will beep
Single User installation,
TimeTrax™ Time & Attendance software should not
Employee punches generated from swipe card are stored within the terminal.
be installed on server PC's.Pyramid Time Systems
does not support the use of TimeTrax™ software
The terminal stores the last 6,000 punches before download is required.
on a server PC. For Multi User Upgrade, call
Depending upon usage, punches can be retrieved on a more or less frequent
888.479.7264 Ext. 1.
basis.
Windows 8 or above
All Windows updates must be installed
prior to software installation
TM
Must be Primary Admin
English
Regional settings & hardware
input in English
Connect either end of RJ45 cable into "SERIAL USB" port located on
1
IMPORTANT:
the back of time clock terminal.
Please write down serial #
2
Connect free end of RJ45 cable to the USB Adaptor.
located on back of terminal
before mounting.
3
Plug free end of USB Adaptor into UBS port on PC.
Connect power supply into "POWER" port located in compartment on
Write your serial # here:
4
back of terminal.
5
Route the cables through channel at base of terminal.
6
Mount terminal (see instructions below).
Plug power supply into outlet.
7
Using Time Clock
Connect Terminal
2
3
1
4
5
7
Advertisement
