Advertisement
TTEZ Terminal
TimeTrax™
Swipe Cards (25)
Part #41302
What you will need.
Tape Measure
Mount Terminal
Contents
6
TTEZ Quick
Start Guide
Power
Supply
RJ45 Cable
Pencil
To mount terminal.
•
Install mounting brackets with tabs. Using
provided mounting screws and drill template.
Be sure the four metal tabs are facing upward.
•
Additional holes are provided if mounting onto
an electrical box.
•
Push terminal onto mounting bracket aligning
four tabs on bracket with four matching slots
on back of terminal.
the terminal serial number before mounting,
slide terminal downward until locking tab
clicks into place. When properly mounted,
terminal cannot be removed from the bracket
without using the included wall bracket release
key to disengage locking tab.
•
Cables may be rooted through channel at base
of terminal or by drilling a hole in the rectan
gular section of the mounting bracket and
RJ45/USB
through the wall for concealing cables.
Connector
To detach terminal.
•
Insert key (tab facing outward) into narrow slot
located on bottom of terminal to right of cable
access cutout.
•
Push key all the way up into slot. Key will slide
easily until last ½ inch until some resistance
from locking tab is felt.
•
With key fully pushed into slot, slide the termi-
nal up and off mounting bracket.
Phillips Head
Power Drill
Screw Driver
(Optional)
Be sure to write down
Mounting
Hardware
Security Bracket
& Key
Advertisement
