Technical Support - Tripp Lite SNMPWEBCARD Owner's Manual

Features
PS/2 Port: Use this port to connect a Tripp Lite ENVIROSENSE environmental
A
sensor (sold separately) for remote temperature/humidity monitoring and dry
contact interface.
Note: Do not connect a keyboard or mouse to this port.
Mini-DIN Serial Port: Use this port to provide a direct connection to a computer
B
with a terminal emulation program. A serial cable (part number 73-1025) is
included with the SNMPWEBCARD.
Ethernet Port: Use this RJ-45 jack to connect the SNMPWEBCARD to the
C
network with a standard Ethernet patch cable. The Link LED
indicate several operating conditions, as shown in the table below. The
C2
recessed SNMP reset button
faceplate located below the RJ45 network port and between the Link and Status
LEDs.
SNMPWEBCARD Operating Conditions
Link LED Color
C1
Off
Flashing Amber
Flashing Green
Status LED Color
C2
Off
Steady Green
Flashing Amber

Technical Support

Technical Support can be found at: www.tripplite.com/support
15-09-060-9334EC.indb 3
is accessible through a small hole on the
C3
B
A
A
C1
No Network Connection
100 Mbps Network Connection
10 Mbps Network Connection
Card Not Initialized
Card Initialized and Operational
Error - Card Not Initialized
3
and Status LED
C1
C
C3 C2
10/13/2015 9:34:06 AM