Canon EOS 7 Service Manual page 26

5-7 Exposure compensation: (1) AEB (Autoexposure bracketing)
1)Availability: AEB is enabled with the Func. setting and settable in
the modes listed in the table below.
2)Bracketing range: 0 to ±2 stops in 1/2-stop increments.
3)Bracketing sequence: Correct exposure, underexposure, and
overexposure.
* Compatible in the single-frame and continuous film advance
modes.
* With the self-timer, all three bracketed shots will be taken after the
10-sec. self-timer delay.
4)Bracketing method: How each picture-taking mode brackets the exposure
is shown in the table below. (The bullet indicates the exposure
compensation method used.)
Mode
Intelligent Program AE
Shutter speed-priority AE
Aperture-priority AE
Depth-of-field AE
Manual
5)AEB cancellation: Enabled by setting the AEB range to 0.
6)AEB reset to first frame: After AEB starts, the bracketing sequence
will be reset to the first frame if any of the following is executed:
The batteries are replaced, the flash is ready, the bracketing
amount is changed, the Command Dial is turned, midroll film
rewind is started.
* AEB is not canceled even after the lens is interchanged.
* AEB is not available in the Full Auto and Programmed Image Control
modes.
(2) Manual exposure compensation
1)Availability: Exposure compensation is enabled in the modes listed
in the table below.
2)Compensation amount: ±2 stops in 1/2-stop increments.
3)Compensation method: How each picture-taking mode
compensates the exposure is shown in the table below. (The bullet
indicates the exposure compensation method used.)
Mode
Intelligent Program AE
Shutter speed-priority AE
Aperture-priority AE
Depth-of-field AE
Manual
4)Exposure compensation cancellation: Enabled by setting the
amount to 0.
* Exposure compensation is not available in the Full Auto and
Programmed Image Control modes.
* If AEB and exposure compensation are combined, the AEB range
will be shifted in accordance with the exposure compensation
amount.
(3) Flash exposure compensation
1)Compatible flash: Built-in flash and EOS-dedicated external
Speedlite.
2)Setting method: With Func. setting.
3)Compensation amount: ±2 stops in 1/2-stop increments.
4)Flash exposure compensation cancellation: Enabled by setting the
amount to 0.
* If flash exposure compensation is set with both the camera and
external Speedlite, the Speedlite's setting will override the
camera's.
* Flash exposure compensation is not available in the Full Auto and
Programmed Image Control modes.
1-19
Part 1: General Information
Shutter Speed Aperture
.
.
.
.
Shutter Speed Aperture
.
.
.
.