Table of Contents
Advertisement
Available languages
Available languages
EN
b2 -
Position the feeding duct (B) on the insert (A1) of the motor unit (A).
b3 -
Rotate the feeding duct (B) anticlockwise to lock its position.
A1
B
b2
Make sure that the Teflon seal (X) is mounted on the
endless screw (H) and that it is intact.
If not, replace it by going to a retailer.
b4 -
Insert the auger (H) in the feeding duct (B) attaching it to the motor pin.
b5 -
Position the star blade (I) on the auger (H) with its edge side facing outwards.
Positioning the star blade (I) with its sharp edge towards the auger (H) will cause the
appliance to not function correctly.
The star blade (I) is very sharp. It can cause injury!
B
H
b4
b6 -
Position the chosen grinding disk (L, M or N) in the
feeding duct (B) aligning the two protruding disk ridges
with their respective slots.
34
A
b3
H
I
b5
B
OK !
b6
X
H
NO !!!
Advertisement
Table of Contents
