Preparating Your Projector - Mitsubishi HC2000 User Manual

Preparating your projector

Checking accessories
The following accessories are provided with this projector. Check to be sure that all of the accessories are packed
in the package.
Power supply parts
Power cord (two)
(42.50115.021, 42.50122.011)
Cables
D-SUB 9P
D-SUB 9P
RS-232C cable
(42.86603.001)
• Used for adjustment by service person.
IMPORTANT:
• The attached power cords are to be used exclusively for this product. Never use them for other products.
1
2
Caution:
• If the batteries are treated incorrectly, they may cause fire or other contamination due to leakage of the
liquid, heating, or they may burst. (Read the cautions indicated on the battery, too.)
• Do not use a new battery with an old one.
• Load batteries in the correct position.
• Do not heat, take apart, or throw batteries into fire.
• Do not try to recharge batteries. Do not use rechargeable batteries.
• If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes
in contact with your eyes, rinse them with water and then consult your doctor.
EN-6
Remote control parts
Mini D-SUB 15P
Mini D-SUB 15P DVI-
conversion cable (42.80H04.001)
Inserting the batteries into the remote
control
1. Remove the rear lid of the remote control.
2. Check the polarity (+), (-) of the batteries, and set them
correctly, inserting their (-) side first.
3
• If the battery is inserted from the (+) side first,
3. Attach the rear lid.
Important:
• Use two size-AAA batteries (R03).
• Replace the two batteries with new ones when the
remote control is slow to operate.
Remote control
(45.80H01.002)
Others
• Lens cap (Attached to the
projector) (51.80H05.001)
• User manual (36.81F01.001)
• Quick Start up (36.81F02.001)
• Remote control photo-sensor
protection sticker (two)
DVI (35.80H03.001)
• Cushion (See page 11.)
inserting the (-) side is difficult because the coil spring
end hits on the battery side. If the battery is forced to
insert in this way, the outer label of the battery may
get ripped and it may cause a short-circuit and
heating.
R03 (Size-AAA)
battery (two)