Table of Contents
Advertisement
Viewing video images (continued)
C. Projectiing images
Preparation:
• Remove the lens cap.
• Turn on the power of the connected equipment.
POWER button/
POWER indicator
LAMP
TEMP
POWER
Main power switch
AC IN
MAIN
LENS SHIFT
Lens shift dial
DOWN
UP
ZOOM IN / UP
ZOOM IN / UP
ZOOM IN, OUT buttons
FOCUS +/- buttons
FOCUS -/LEFT
FOCUS -/LEFT
FOCUS +/RIGHT
FOCUS +/RIGHT
ZOOM OUT / DOWN
ZOOM OUT / DOWN
AUTO
AUTO
POSITION
POSITION
SOURCE MENU/EXIT
SOURCE MENU/EXIT
ENTER
ENTER
SOURCE button
ON
STANDBY
ON(
)button
AUTO
SOURCE button
ZOOM IN/UP
{, } button
FOCUS–/LEFT
$, % button
MENU
ZOOM OUT/DOWN
EN-20
1. Turn the main power switch to on (or to the I position).
2. Press the POWER button on the projector or ON ( ) button on
LIGHT
OFF
DVI-A
Video
3. Select an input source.
16:9
MEM2
FOCUS+/RIGHT
ENTER
4. Adjust the position of the projector to keep an appropriate
5. Adjust the position of the projector so that the projector and the
6. Adjust the size of the projected image by pressing the ZOOM IN
7. Adjust the focus by pressing the FOCUS+ or FOCUS- button on
8. Adjust the image position by turning the lens shift dial of the
• When the main power switch is turned on, the POWER
indicator lights up red.
LAMP TEMP
POWER
Lighting in red
• If the projector was turned off before the lamp was cooled
down sufficiently last time, the fan may start rotating and
the POWER button may not work after the main power
switch is turned on. (The POWER indicator blinks red.) After
the fan stops rotating, press the power button to turn back
on the POWER indicator.
the remote control.
LAMP TEMP
POWER
Blinking
in blue
Power can not be turned "OFF".
• It may take about one minute for the lamp to light up.
• The lamp fails to light up on rare occasions. In such a case,
wait for a few minutes and then try again.
• Press the SOURCE button on the projector or any of the
SOURCE buttons (such as DVI-D, DVI-A, and BNC) on the
remote control that is corresponding to the terminal in use.
• Switch the input source after an image is projected on the
screen.
• Though it may take some time before an image is displayed
on the screen depending on the type of the input signal, such
symptom is not a malfunction.
• Images may not be projected in the correct position,
depending on the type of the input signal. In such a case,
press the AUTO POSITION button on the projector or the
AUTO button on the remote control. (See Page 21.)
projection distance with which images are projected in their
specified sizes.
screen are perpendicular to each other. (See Page 11.)
• When the projector cannot be positioned perpendicularly to
the screen, adjust the projection angle. (See Page 11.)
or OUT button on the projector or the remote control.
the projector or the remote control.
projector.
Repeat steps 4 to 8, if necessary.
LAMP TEMP
POWER
After about
1 minute.
Lighting in
blue
Advertisement
Table of Contents
